Anti theft device for use with the ATTx V2 Receiver and ATT Mini Receiver. Simply wire the Car Pager either into your car alarm or directly into the car's ignition circuitry or alternatively it may be used with the ATT Ultrasonic Sensors.
- Simple to install and use.
- No batteries required.
- Full instructions included.
- Full 2 year ATT Warranty. Please see the ATT website for full details.
Car Pager Operation:
The unit is activated when your car door is opened. Once triggered the pager unit will transmit signals to the ATTx V2 Receiver which sends the receiver into 'Alarm Mode'. The unit will transmit the signals three times, then pause for an hour, then re-transmit the signals again after an hour. This process is repeated until the pager unit is reset. Turning on the vehicle ignition will reset the pager unit.
If the optional Ultrasonic Sensors are fitted, the pager will also be triggered if your vehicle window is smashed.
ATTx V2 Receiver Alarm Mode - The Receiver will continuously emit a siren-like tone lasting for 5 seconds as well as flashing all the LEDs simultaneously. To stop the siren tone (and cancel Alarm Mode) tap the Receiver Button once. The Receiver will revert back to it's normal mode of operation.
Mini Receiver Operation - When triggered by the Car Pager, the Mini Receiver is activated and will vibrate and beep 5 times. Pressing the 'L' button will de-activate the Mini Receiver for 15 minutes. After the 15 minute period the Mini Receiver will be re-activated and continue normal use.